Product Code
Product description
Product Picture
Info
Product Position
OLD FLANGE NUT (7 MM HOLE)
This flange nut is used when a 7mm hole is drilled rather than a 9mm hole. This is also used on the UltraSky roofing system
SPIGOT NUT (9MM HOLE)
used inconjunction with the twin bolts/ single bolts. The nuts spigot sits inside the 9mm hole in the glazing bar
MS POLYIMER SEALANT
To be used on ALL Active glass and associated areas on roofs with Active glass installed.
MUNTIN BAR
used to expand glass when the sizes are too large for the units to be made.
ROOFING NOTE AND BOLT PACK M6 ROUND HEAD
used to secure glazing bars to the PWLA wallplate
ROOFING NOTE AND BOLT PACK M6 SQUARE HEAD
used to secure glazing bars to the eaves and ridges (old product fabricators only for fab ends)
SQUARE HEAD SINGLE BOLT 21.5mm long
used on both eaves and ridge bodies to secure the glazing bars where doubles can't be used I.E. 90 degree corners
SQUARE HEAD SINGLE BOLT 30mm long
used on both eaves and ridge bodies to secure the glazing bars where doubles can't be used I.E. 90 degree corners
TWIN BOLT
used on both eaves and ridge bodies to secure the glazing bars
WASHER
Used when using a spigot nut on a slotted end. This packs out the spigot end and stops the bolt being pulled through the radius slot
10mm T BAR SPANNER
used to assemble the glazing bar rafter bolts and jack rafters kits on installation.
13mm T BAR SPANNER
used to assemble the valley rafter kits on installation.